I started playing with microcontrollers in 2005 and, if not at the very start, at least very quickly I decided to aim to have some sort of remote controlled Linux device with controllable camera with digital wireless communication. Now, 6 years later, I have completed my first phase :)
Couple of photos of the earlier devices are shown in the project page.
After several planning iterations and code rewrites I ended up using Qt both on the remote controlled Gumstix and on the GUI controller. I decided that trying to optimize everything from the memory and CPU consumption to the network bandwidth just isn’t worth the time spent in implementing it. The most CPU intensive task is the video encoding to H263 and that’s done in the DSP. I’m running MeeGo on the Gumstix and it provides e.g. the GStreamer plugins for the DSP.
Using Qt framework with self made simple protocol over UDP I got the Phase01 code implemented quite quickly compared to my previous efforts. The protocol allows low priority packets (like periodic statistics and video stream) to be lost and guarantees the passing of high priority packets (control commands etc.). Also only the latest control command of each type is retransmitted, i.e. an old packet is not retransmitted if a new overriding command has already been given.
The controller GUI shows the states the slave sends, like motor speeds, WLAN signal strength, CPU load average and some protocol statistics like round trip time and the number of retransmissions.
Currently the motors are controlled using the a,s,d,w keys in 10% steps and the camera is controlled dragging the mouse left button pressed on top of the video window.
Here’s a video (direct link) of the Phase01. You need HTML5 video capable browser with Ogg Theora/Vorbis codecs.
